How to make a whiteboard or notes photo readable
A quick phone photo of the board at the end of a lesson or meeting often comes out grey, tilted and full of glare. A few steps turn it into a clean page you can read, print or share.
By Metin Ersoy · Updated November 10, 2026
The short version
- Trim the photo with Crop image so only the board is left.
- Open Adjust image brightness, raise Brightness by about 20 and Contrast by 30 to 50.
- If colour does not matter, choose Pure black and white in Black and white image for a clean page.
- Put several boards or pages into one file with JPG to PDF.
Each tool keeps the original file untouched, so you can go back a step at any time.
Take a better photo in the first place
A few seconds before pressing the button save more than any editing afterwards:
- Stand straight in front of the board, not off to one side. A tilted photo makes the far end small and blurry.
- Move a step to the side if you see a bright spot from the ceiling lights or a window. A small angle is better than a reflection over the writing.
- Tap the board on the screen so the phone measures the light there.
- Fill the frame with the board; empty wall and people around it only waste pixels.
- Turn off the flash. On a glossy whiteboard it creates exactly the glare you want to avoid.
Settings for typical boards
| Board | Brightness | Contrast | Then |
|---|---|---|---|
| Whiteboard with black or blue marker | +15 to +25 | +35 to +50 | Black and white if you will print it |
| Whiteboard with several marker colours | +15 | +25 to +35 | Keep colour, add saturation +15 so the colours stay apart |
| Blackboard or green chalkboard | 0 to +10 | +40 to +60 | Invert the colours for a white page with dark writing |
| Handwritten notebook page | +20 | +30 | Black and white, then compress to share |
| Flip chart or sticky notes | +10 | +20 | Keep colour; saturation +10 to +20 |
Watch the preview: when the lightest marker colour starts to disappear, go back a few steps of contrast.
For a blackboard, the Invert image colors tool turns light chalk on a dark board into dark writing on a white page, which uses far less ink when printed.
Turn the result into notes you can use
- One PDF per lesson or meeting: choose all the edited photos in JPG to PDF, put them in order and download one file.
- Smaller files for a group chat: Compress JPG keeps the writing readable while cutting the size a lot.
- Typed text: neat printed words can be picked up with Image to text. Check the result, since handwriting is often misread.
If something goes wrong
The writing broke into dots after black and white. The marker was too faint. Go back to the edited colour photo, add more contrast first, then try again; or use Grayscale instead of pure black and white.
One corner is still dark. Light usually falls unevenly across a board. Crop the dark corner if it holds no writing, or choose a brightness value that suits the middle and accept a slightly grey corner.
The photo is sideways or the board looks crooked. A sideways photo is fixed with a quarter turn in Rotate image. For a board tilted by a few degrees, the straighten control in your phone's photo app works better. A photo taken from a strong angle cannot be fully straightened; retake it from the front if the board is still there.
Ready to try it? It is free and your file stays on your device.
Open Adjust image brightness