How to scan double-sided documents with a single-sided scanner
Two passes through the sheet feeder, one tool to put the pages back together, and the checks that save you from scanning everything twice
By Metin Ersoy · Updated October 29, 2026
Why two passes are needed
A scanner with a sheet feeder but without a duplex unit reads only the side of the paper that faces the sensor. For a document printed on both sides, the usual trick is to scan the stack twice: once for the fronts, then once more after turning the stack over for the backs.
That gives you all the pages, but in the wrong order. The first pass holds pages 1, 3, 5 and so on. The second pass holds the even pages — and because the stack was turned over, the last sheet goes through first, so the backs come out as 10, 8, 6, 4, 2. Sorting that by hand in a page organiser takes two moves per sheet.
Step by step
- Square the stack. Remove staples and paper clips, straighten folded corners and fan the pages so they do not stick together. Most feeder problems start here.
- First pass: the fronts. Put the stack in the feeder with page 1 facing the way your scanner expects, and scan to PDF. Note the page count.
- Turn the stack over as one block. Take the pages out of the output tray without reordering them, turn the whole stack over and put it back in.
- Second pass: the backs. Scan again with exactly the same colour and resolution settings. The page count should match the first pass.
- Combine the passes. Open merge odd and even pages, add the front file and the back file, keep "Back sides are in reverse order" switched on and download the result.
- Check four pages. Open the new PDF and look at pages 1 to 4. They should read in order. If page 2 shows the last page of the document, switch the reverse option off and run the tool once more.
If your scanner app adds both passes to one file instead of making two, choose that one file in step 5. The tool takes the first half as the fronts and the second half as the backs.
Settings that make a difference
- Resolution: 300 dpi is enough for letters, forms and contracts. Go higher only for small print or photos; the file grows quickly.
- Colour mode: grey or black-and-white scans are much smaller than colour. Use colour only when it carries meaning, such as stamps, signatures in blue ink or highlighted text.
- Same settings for both passes: a colour front next to a grey back looks odd and makes the file bigger than it needs to be.
Cleaning up the result
- Blank backs from single-sided sheets: remove them with delete PDF pages. The guide on removing blank pages shows how to spot them quickly.
- Upside-down backs: some feeders turn the paper so that the backs come out rotated. Fix them all at once with rotate PDF.
- Too large to send: shrink the file with compress PDF. The guide on reducing the size of a scanned PDF explains which setting to pick.
- Need to search or copy the text: a scan is a picture. Make it searchable with OCR PDF.
Common mistakes
- Reordering sheets between passes. Once the order of the stack changes, the two passes no longer line up and no tool can guess the right pairs. Keep the stack exactly as it came out.
- Skipping the page count. A double pull or a jammed sheet changes one pass but not the other. Comparing the two counts takes a second and tells you before you send the file.
- Scanning only some backs. If you skip the blank backs to save time, the pairs shift. Scan every sheet and delete blank pages at the end.
Ready to try it? It is free and your file stays on your device.
Open Merge odd and even pages